Chapter 8 Mold Diagnostics; Testing The Mold - Husky Altanium Matrix2 User Manual

User Guide

Chapter 8 Mold Diagnostics

Diagnostics is a useful tool for troubleshooting problems with a mold or for verifying the
wiring integrity of a mold after maintenance has been performed. Diagnostics can also be
used to analyze the thermal isolation between all the cavities in the mold.
8.1

Testing the Mold

To test the mold, do the following:
1.
2.
3.
4.
5.
Figure 8-1 Mold Diagnostics Screen
1. Run Test 2. Stop Test 3. View Test Results
Testing the Mold
On the Home screen, touch the Mold Diagnostics button.
Make sure Altanium is in the stop state.
Select the desired zone(s).
Select the check box(es) for the desired test(s).
Touch the Run Test button.
1
2
3
v 1.1 — July 2015 Mold Diagnostics
85