Sack Full Output Optimization - Husky Altanium Matrix2 User Manual

On the Part Counting - Setup dialog box, touch Reset Part Counter. The Parts in Sack
parameter and Parts display on the system header will be reset to zero.

10.1.14.1.2 Sack Full Output Optimization

The system will automatically adjust the Sack Full Limit if an abort condition error occurs
while the system is in the 'Running' state and the PCM parameter is set to 'Zone' on the Quick
Set screen.
To allow the system to optimize the sack full limit, do the following:
1.
Figure 10-12 Quick Set Showing PCM - Priority Control Mode
128
On the Quick Set screen, set the PCM - Priority Control Mode to Zone. The system will
automatically adjust the sack full limit when an abort condition error occurs. The
following are abort condition errors:
• Abort Over Temperature
• Abort Under Temperature
• Fuse 1 Blown
• No Response
• Lost T/C
• Reverse T/C
• Fuse 2 Blown
• Earth Leakage
• Over Maximum Temperature Limit
• Over Current Limit
• Configuration
• Receive Data Communication
• Read Time Out
• Control Card Over Temp
v 1.1 — July 2015 Altanium Matrix2
Sack Full Output Optimization