Creating A Leader Line - Husky Altanium Matrix2 User Manual

User Guide
4.
Figure 11-9 Change View Settings Dialog Box
1. Select File Name Button 2. Image File Name Field 3. First Selection Field 4. Second
Selection Field 5. Views Button Name 6. Zone Information Panel
5.

11.3.2.4 Creating a Leader Line

Create leader lines to clarify the connection between a Zone Information Panel and the
associated heat zone. Create a Zone Information Panel before creating a Leader Line.
To create a Leader Line, do the following:
1.
2.
3.
Creating a Leader Line
To configure the content of the Zone Information Panel, do the following:
• To change the first selection displayed on the Zone Information Panel, touch the
First Selection field and select one of the following: Zone Name, Current
Temperature Setpoint, Actual Temperature, Power Output, or Amperage.
• To change the second selection displayed on the Zone Information Panel, touch
the Second Selection field and select one of the following: Zone Name, Current
Temperature Setpoint, Actual Temperature, Power Output, or Amperage.
1 1
6
4
Touch the Accept button.
Make sure Mold Picture View is in Edit mode.
Touch the desired Zone Information Panel.
Touch and drag the Flag button to the desired location on the mold picture view
graphic. A Leader Line appears between the flag and the Zone Information Panel.
v 1.1 — July 2015 Mold Picture View
2
3
4
5
3
149