Enabling Soft Start; Disabling Soft Start; Adjusting The Soft Start Minimum Limit; Alarm Screen - Husky Altanium Matrix2 User Manual

9.3.1 Enabling Soft Start

Once soft start is enabled, it will be applied the next time the mold heats are turned on.
To enable soft start, do the following:
1.

9.3.2 Disabling Soft Start

Once soft start is disabled, it will not be applied until the next time the mold heats are turned
on.
To disable soft start, do the following:
1.

9.3.3 Adjusting the Soft Start Minimum Limit

The soft start limit is used to calculate the window between the lowest temperature zone and
the highest temperature zone in the system. This window is maintained throughout the soft
start process and determines the gap between the coldest and hottest zones. Generally,
lowering the soft start limit value decreases this gap, contributing to greater thermal
uniformity of the hot runner system from a cold startup.
To adjust the soft start minimum limit, do the following:
1.
2.
9.4

Alarm Screen

The Alarm screen displays any errors that occur. When an alarm is active, an icon in the
Alarms button in the system footer turns yellow and flashes red. Touch the Alarm button to
open the Alarm screen.
NOTE:
98
On the System Setup screen, select the Soft Start Enable check box.
On the System Setup screen, clear the Soft Start Enable check box.
On the System Setup screen, touch the Soft Start Minimum Limit field.
Enter the soft start minimum limit value.
For a description of the alarm conditions displayed on the Event History screen and
Alarm screen, refer to
on the Event History screen and Alarm screen, refer to
v 1.1 — July 2015
Section 9.7. For a description of the abort conditions displayed
Altanium Matrix2
Section 9.8.
Enabling Soft Start