Replacing An Altanium Matrix2 Display Module; Disconnecting The Display Module - Husky Altanium Matrix2 User Manual

CAUTION!
Static electricity hazard - risk of damage to the equipment. Do not, under any
circumstances, place any PCB on carpets, rugs, or other material that is likely to create
a static charge.
4.
5.
6.
7.

15.4 Replacing an Altanium Matrix2 Display Module

WARNING!
Static electricity hazard - risk of damage to the equipment. Turn off all power to the
system and disconnect it completely from the main input power.
Use a ground strap when handling the Altanium components.
In some cases, Altanium will not work if the display is defective. If the display input power is
correctly connected and all three phase indicators are lit; the display is probably faulty.

15.4.1 Disconnecting the Display Module

To disconnect the display module, do the following:
WARNING!
Electrical and mechanical hazard - risk of death, serious injury and/or damage to the
equipment. Turn off all power to the system and disconnect it completely from the
main input power. Use a ground strap when handling any of the Altanium
components.
1.
182
Carefully place the card on an earthed/grounded surface.
Remove and replace the faulty fuse with one of identical type and rating. Husky
recommends SIBA 71-25-40 Series or equivalent fuses. Make sure the fuse is fully seated.
Poor seating will cause a hot spot, which can cause problems for the system.
NOTE:
20 and 30 Amp cards will only have two fuses.
Slide the new card into to the slot and push the card slowly and firmly back into place.
An incorrectly oriented card will not seat properly.
Tighten the upper and lower slotted screws on the heat sink.
Facing the rear of the system, disconnect the Power and Input Comm cables from the
mainframe.
v 1.1 — July 2015
Replacing an Altanium Matrix2 Display Module
Altanium Matrix2