Connecting The Display Module; Mounting The Display Module Remotely - Husky Altanium Matrix2 User Manual

15.4.2 Connecting the Display Module

To connect the display module, do the following:
IMPORTANT!
A minimum of 2 people are required to perform this procedure.
1.
Figure 15-11 Connecting the Altanium Interface Plate to the Mainframe
1. Button Head Cap Screws
2.
3.

15.4.3 Mounting the Display Module Remotely

The display module can be mounted remotely if the Remote Mount option is ordered.
To mount the display module remotely, do the following
IMPORTANT!
A minimum of 2 people are required to perform this procedure.
1.
2.
184
Facing the front of the controller, locate the four 1/4 inch-20 button head cap screws
that hold the Altanium interface plate to the mainframe.
1
Install the four screws using the 5/32 inch hex wrench provided with the controller.
Facing the rear of the system, connect the Power and Input Comm cables to the
mainframe.
NOTE:
The main power for the Altanium display module can only come from the
mainframe Display Power connection.
Place the display module in the mounting location.
Using screws, secure the display module in position.
v 1.1 — July 2015 Altanium Matrix2
Connecting the Display Module