Diagnostics Export; Part Counting; Setting Up Part Counting - Husky Altanium Matrix2 User Manual

10.1.13 Diagnostics Export

Diagnostics Export allows users to export diagnostics files to a USB drive. This feature is
intended for Husky Technical Support use only. Please contact Husky for assistance if
required.

10.1.14 Part Counting

Optional digital inputs and an output are available to automatically count up parts, including
the ability to set a sack full limit. This eliminates the need for users to manually calculate
when sack is full.

10.1.14.1 Setting Up Part Counting

To set up Part Counting, do the following:
1.
2.
3.
4.
5.
The Parts in Sack parameter will display the current number of parts in the sack. The current
number of parts will also be displayed in the system header.
126
On the System Setup screen, under Part Counting, select Setup. A dialog box appears.
Select Assign Heater Types if not previously done. This will bring up the Quick Set
screen. For more information refer to
NOTE: The Heater Type parameter must be set to Tips for all zones that pertain to a
cavity in the mold. If no zones have a Heater Type parameter assigned, an error
message will appear.
Select Part Counting Enable.
Enter the desired Sack Full Limit to specify how many parts are required for the system
to consider the sack full. This number can be adjusted from 1 to 1,000,000.
Select Configure Digital I/O if not previously done. This will bring up the Digital I/O
screen. For more information on configuring digital inputs/outputs refer to
v 1.1 — July 2015
Section 7.5.8.
Altanium Matrix2
Section 13.1.
Diagnostics Export