Changing The Units Of Measure; Changing The Energy Usage And Units - Husky Altanium Matrix2 User Manual

Figure 10-3 System Setup Screen - Data Collection
1. Data Collection Area

10.1.3 Changing the Units of Measure

Users can configure Altanium to display the international system of units (SI) or the imperial
units of measure.
To change the units of measure, do the following:
1.
2.
3.
NOTE:

10.1.4 Changing the Energy Usage and Units

Energy accumulation data is updated every three seconds and presented in real time to the
user on the Energy Display screen. Users can enter Energy Cost Rate (Kwh) and Currency
Type through the Energy Usage and Units section in the System Setup screen.
114
1 1
On the System Setup screen, under User Settings, touch the Units button.
Change the desired units of measure.
Touch the Exit button.
If Altanium is forced to a specified setting, only administrators can change the units
of measure.
v 1.1 — July 2015 Altanium Matrix2
Changing the Units of Measure