Edit Mode; Configuring A Zone Information Panel; Creating A Zone Information Panel - Husky Altanium Matrix2 User Manual

11.3.1 Edit Mode

To put Mold Picture View into Edit mode, do the following:
1.
Figure 11-6 Mold Picture View Screen
1. Edit Button 2. Views

11.3.2 Configuring a Zone Information Panel

Each Zone Information Panel provides three pieces of information about a zone. A Zone
Information Panel always contains a zone number. The other two pieces of information
displayed on a Zone Information Panel can be chosen from the following list:
•
•
•
•
•
NOTE:

11.3.2.1 Creating a Zone Information Panel

A Zone Information Panel provides information about a zone. To create a Zone
Information Panel, select a zone and then configure a Zone Information Panel to display
the desired information about the zone selected.
146
On the Mold Picture View screen, touch the Edit button.
1
Zone Name
Current Temperature Setpoint
Actual Temperature
Power Output
Amperage
Actual earth leakage is an option when ICC
leakage parameter is set.
v 1.1 — July 2015
3
cards are installed and the display earth
Altanium Matrix2
2
Edit Mode