Safety Information - Keysight InfiniiMax III N2800A Series User Manual

Safety Information

This product has been designed and tested in accordance with accepted industry
standards, and has been supplied in a safe condition. The documentation contains
information and warnings that must be followed by the user to ensure safe operation and
to maintain the product in a safe condition.
To avoid personal injury and to prevent fire or damage to this product or products
connected to it, review and comply with the following safety precautions. Be aware that if
you use this probe assembly in a manner not specified, the protection this product provides
may be impaired.
In addition to the safety notices in this section, also refer to the CAUTION and WARNING
notices listed in other sections of this guide.
Observe Probe Ratings. Do not apply any electrical potential to the probe input which
WARNING
exceeds the maximum rating of the probe.
These probe assemblies are NOT intended for measurements on circuits rated for
CAT II, CAT III, or CAT IV.
Indoor Use Only. Do not operate in wet/damp environments. Keep product surfaces
WARNING
dry and clean.
Never leave the probe connected to a conductor while it is not connected to an
WARNING
oscilloscope or voltage measuring instrument.
Periodically inspect the probe and probe wires to check for any damage. Do Not
WARNING
Operate With Visible or Suspected Failures. If you suspect there is damage, have it
inspected by a Keysight authorized service personnel.
Do not install substitute parts or perform any unauthorized modification to the
WARNING
probe.
Do not operate the probe or oscilloscope in the presence of flammable gasses or
WARNING
fumes. Operation of any electrical instrument in such an environment constitutes a
definite safety hazard.
If the probe is used in a manner not specified by the manufacturer, the protection
WARNING
provided by the probe assembly may be impaired.
Do not attempt internal service or adjustment. Service should be carried out by a
WARNING
Keysight Technologies authorized service personnel. For any service needs, contact
Keysight Technologies.
InfiniiMax III Series Probes User's Guide
Using InfiniiMax III Series Probes
1
19