Agilent Technologies 1100 Series Reference Manual page 318

9
Introduction to the Control Module
EMF (Early Maintenance Feedback)
Use the F1 key (EMF) to set EMF parameters. Choose menu item 1 (Setup
limits) to select lamp-on level for the Xenon lamp at which you want to receive
a warning.
If a set limit has been exceeded, a message box will pop up. This will not stop a
sequence or run (information only to plan maintenance activities). If you
press Reset, the limits will be removed. Ignore will continue to keep the EMF
flag set.
320 1100 Series FD Reference Manual