Agilent Technologies 1100 Series Reference Manual page 314

9
Introduction to the Control Module
System - Control
Use the F1 key (Control) to select the FL-Detector. Here you receive
information about the not-ready conditions if needed. F2 key (Reset) does a
re-initialization of the FLD. Use the F8 key (On/Off) to turn on the lamp(s).
System - Configuration
Use the Esc key to receive Views on the F5 key. Choose System from the
pull-down menu. Use the F2 key (Configure) to select the FLD. Here you
define further special setpoints for the FLD operation.
316 1100 Series FD Reference Manual