5 Turn the pump on and flush with water for a few minutes to assure a clean
You may remove the flow cell and check for air bubbles. After re-inserting the cell, turn the
NO TE
lamp on.
6 From the Analysis screen select Settings - FL Detector. Press then the
Figure 37
7 Press the Store button a few times to store a few spectra in a temporary
8 Press the Eval button to change to the following screen.
Figure 38
1100 Series FD Reference Manual
flow cell. Flow rate should be 0.5 to 1 ml/min and the baseline stable.
Spectrum button will open the window below.
Online Emission Spectra
buffer.
Evaluating Online Emission Spectra
Troubleshooting and Test Functions
4
107