Agilent Technologies 1100 Series Reference Manual page 23

8 Connect the APG remote cable (optional) for non-Agilent 1100 Series
9 Turn on power by pushing the button at the lower left hand side of the
Interface board
LAN or BCD/EXT
Analog signal
APG remote
RS-232C
Figure 6
The detector is turned on when the line power switch is pressed and the green indicator
NO TE
lamp is illuminated. The detector is turned off when the line power switch is protruding and
the green light is off.
To disconnect the detector from line, unplug the power cord. The power supply still
WA RN ING
uses some power, even if the power switch at the front panel is turned off.
The detector was shipped with default configuration settings. To change these settings see
NO TE
"Setting the 8-bit Configuration Switch"
1100 Series FD Reference Manual
instruments.
detector. The status LED should be green.
Rear View of Detector
Installing the Fluorescence Detector
CAN
GPIB
Configuration switch
on page 290.
Security lever
Power
1
23