Gpib Default Addresses - Agilent Technologies 1100 Series Reference Manual

In the non-volatile memory, the parameters are kept, regardless of whether
you turn the instrument off and on again. They will be kept until the same set
of parameters is changed and the power is reset. All other previously stored
configuration settings will still remain in the non-volatile memory.
In this way, you can store more than one set of parameters using the same
8-bit configuration switch twice, for example, for both GPIB and RS-232C.

GPIB Default Addresses

If you just want to change the GPIB address and need a detailed procedure,
refer to the Installing Your Agilent ChemStation System handbook.
Default GPIB address is set to the following addresses:
Table 65
where 0 means that the switch is down and 1 means that the switch is up.
1100 Series FD Reference Manual
Default Addresses for Agilent Series 1100 Modules
Module
Pump
FLD
VWD
Agilent 8453A
DAD / MWD
Column compartment
Autosampler
RID
Address Binary Address
22 0 0 0 1 0 1 1 0
23 0 0 0 1 0 1 1 1
24 0 0 0 1 1 0 0 0
25 0 0 0 1 1 1 0 1
26 0 0 0 1 1 0 1 0
27 0 0 0 1 1 0 1 1
28 0 0 0 1 1 1 0 0
29 0 0 0 1 1 1 0 1
Theory of Operation
291
8