Comparing The Parameters - Vacon 100 flow Applications Manual

VACON · 100
SAVING THE PARAMETERS TO THE CONTROL PANEL
1 Go into the User settings menu.
2 Go into the Parameter backup submenu.
3 Use the arrow buttons Up and Down to make a
selection of a function. Accept the selection with
the OK button.
The command Restore factory defaults brings back the parameter settings that were made
at the factory. With the command Save to keypad you can copy all the parameters to the
control panel. The command Restore from keypad copies all the parameters from the
control panel to the drive.
3.2.5

COMPARING THE PARAMETERS

With this function, you can compare the current parameter set with 1 of these 4 sets.
Set 1 (P6.5.4 Save to Set 1)
•
Set 2 (P6.5.6 Save to Set 2)
•
The defaults (P6.5.1 Restore Factory Defaults)
•
The keypad set (P6.5.2 Save to Keypad)
•
See more about these parameters in Table 114 The parameter backup parameters in the user
settings menu.
3
LOCAL CONTACTS: HTTP://DRIVES.DANFOSS.COM/DANFOSS-DRIVES/LOCAL-CONTACTS/
USER INTERFACES
STOP READY
Main Menu
ID: M6
I/O and Hardware
( 9 )
User settings
( 4 )
Favourites
( 0 )
STOP READY
User settings
ID: M6.5
Language selection
English
Parameter backup
( 7 )
Drive name
Drive
STOP READY
Parameter backup
ID: M6.5.1
Restore factory defaults
Save to keypad
Restore from keypad
Keypad
Keypad
Keypad