Vacon 100 flow Applications Manual page 373

FAULT TRACING
Fault
Fault ID Fault name
code
37 361 Device changed
(same type)
362 Device changed
(same type)
363 Device changed
(same type)
364 Device changed
(same type)
365 Device changed
(same type)
38 372 Device added (same
type)
373 Device added (same
type)
374 Device added (same
type)
375 Device added (same
type)
39 382 Device removed
383 Device removed
384 Device removed
385 Device removed
40 390 Device unknown
LOCAL CONTACTS: HTTP://DRIVES.DANFOSS.COM/DANFOSS-DRIVES/LOCAL-CONTACTS/
Possible cause
The power unit was
replaced by a new one that
has the same size. The
device is ready to be used.
The parameters are availa-
ble in the drive.
The option board in slot B
was replaced by a new one
that you have used before in
the same slot. The device is
ready to be used.
The same cause as in ID362,
but refers to Slot C.
The same cause as in ID362,
but refers to Slot D.
The same cause as in ID362,
but refers to Slot E.
An option board was put into
slot B. You have used the
option board before in the
same slot. The device is
ready to be used.
The same cause as in ID372,
but refers to Slot C.
The same cause as in ID372,
but refers to Slot D.
The same cause as in ID372,
but refers to Slot E.
An option board was
removed from slot A or B.
The same cause as in ID380,
but refers to Slot C
The same cause as in ID380,
but refers to Slot D
The same cause as in ID380,
but refers to Slot E
An unknown device was
connected (the power unit/
option board)
VACON · 373
How to correct the fault
Reset the fault.
The drive reboots after you reset
the fault.
Reset the fault. The drive starts to
use the old parameter settings.
The device is ready to be used. The
drive starts to use the old parame-
ter settings.
The device is not available. Reset
the fault.
The device is not available. If the
fault occurs again, ask instructions
from your nearest distributor.
11