Vacon 100 flow Applications Manual page 334

VACON · 334
K1
Motor 1 control
from relay
K3
K2
K1.1
K1
Fig. 99: Selection 1
P3.15.8 AUTOCHANGE INTERVAL (ID 1029)
Use this parameter to adjust the autochange intervals.
The Autochange interval is the time after which the autochange function starts if the used
capacity is below the set level. The value of this timer does not run when the Multi-pump
system is stopped or in the sleep mode. To use the parameter, select Enabled (interval) with
parameter P3.15.6 Autochange Mode.
The autochange occurs, if:
10
K1.1 K2
M1
Motor 2 control
from relay
K2 K3 K3
K1
K1 K2.1
K1.1 K2
LOCAL CONTACTS: HTTP://DRIVES.DANFOSS.COM/DANFOSS-DRIVES/LOCAL-CONTACTS/
Mains
K2.1 K3
M2 M3
Motor 3 control
from relay
K1 K3 K1
K2
K2 K3.1
K2.1 K3
PARAMETER DESCRIPTIONS
K3.1
K2 K1
K3
K3.1