Vacon 100 flow Applications Manual page 87

WIZARDS
23 Set a value for P3.13.5.1 SP1 Sleep Frequency Limit
24 Set a value for P3.13.5.2 SP1 Sleep Delay
Set a value for P3.13.5.3 SP1 Wake Up Level
25
Set a value for P3.15.1 Multi-pump Mode
26
27 Set a value for P3.15.3 Pump ID Number
Set a value for P3.15.4 Start and Feedback
28
29 Set a value for P3.15.2 Number of pumps
Set a value for P3.15.5 Pump Interlocking
30
Set a value for P3.15.6 Autochange
31
If you set the value Enabled (Interval) to parameter Autochange, step 33 shows. If you set the
value Enabled (Weekdays) to parameter Autochange, step 34 shows. If you set the value
Disabled to parameter Autochange, the wizard goes directly to step 36.
Set a value for P3.15.7 Autochanged pumps
32
Step 33 shows only if you set the value Enabled (Interval) to parameter Autochange in step 31.
33 Set a value for P3.15.8 Autochange Interval
Steps 34 and 35 show only if you set the value Enabled (Weekdays) to parameter Autochange
in step 31.
LOCAL CONTACTS: HTTP://DRIVES.DANFOSS.COM/DANFOSS-DRIVES/LOCAL-CONTACTS/
Range: 0.00-320.00 Hz
Range: 0-3000 s
The range is specified by the set process
unit.
Multifollower
Multimaster
Range: 1-8
0 = Not connected
1 = Only Start Signal Connected
2 = Both Signals Connected
Range: 1-8
0 = Not used
1 = Enabled
0 = Disabled
1 = Enabled (Interval)
2 = Enabled (Weekdays)
0 = Auxiliary pumps
1 = All pumps
Range: 0-3000 h
VACON · 87
2