Internal Usb Device Option - HPE ProLiant DL325 Gen11 User Manual

15. Power up the server.
Results Results
The installation is complete.

Internal USB device option

Internal USB device option
The server has an internal USB 3.2 Gen1 port to install a USB device that can be used as a flash boot media or for data backup/redundancy.
Subtopics Subtopics
Installing the internal USB device Installing the internal USB device
Installing the internal USB device Installing the internal USB device
About this task About this task
CAUTION: CAUTION: A discharge of static electricity from a finger or other conductor might damage system boards or other static-
sensitive devices. To prevent damage, observe antistatic precautions.
Procedure Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. Remove the server from the rack.
5. Place the server on a flat, level work surface.
6. Remove the access panel .
7. Plug in the USB device into the USB port.
8. Install the access panel .
9. Install the server into the rack.
10. Connect all peripheral cables to the server.
HPE ProLiant DL325 Gen11 Server User Guide 185