Table of Contents
Advertisement
3. Install the access panel.
4. Slide the server into the rack.
5. Connect each power cord to the server.
6. Connect each power cord to the power source.
7. Power up the server.
8. Admit the new DSC-25 card to the Pensando Policy and Services Manager (PSM).
For more information, see Pensando Distributed Services Card for Single-Wire Management (DSC-25-SWM) Removal/
Replacement Guide on the Hewlett Packard Enterprise website (https://www.hpe.com/support/dsc25-replacement).
Removing and replacing the HPE NS204i-p NVMe OS Boot Device
option
Removing and replacing the boot device
Prerequisites
Procedure
1.
Observe the following alerts:
CAUTION: The boot device and the drives installed on the boot device are not hot-pluggable. To remove the boot
device, or a drive from the boot device, you must first power down the server.
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system
components to cool before touching them.
2.
Back up all server data.
3.
Power down the system.
Removal and replacement procedures
80
Advertisement
Table of Contents
