Removing And Replacing An Internal Usb Device - HPE ProLiant DL320 Gen11 Maintenance And Service Manual

Results Results
To replace the component, reverse the removal procedure.

Removing and replacing an internal USB device

Removing and replacing an internal USB device
Procedure Procedure
1. Power down the server.
2. If installed, open the cable management arm .
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack .
6. Place the server on a flat, level work surface.
7. Remove the access panel .
8. Remove the riser cage.
9. Unplug the USB device from the USB port.
HPE ProLiant DL320 Gen11 Server Maintenance and Service Guide 181