Initial Setup; Electrical Connections; T102 Analog Output Connections; Figure 3-6. Analog Output Connector - Teledyne T102 Operation Manual

Teledyne API - T102/501 TRS, Addendum to T101 Operation Manual

3.6. Initial Setup

3.6.1. Electrical Connections

3.6.1.1. T102 Analog Output Connections

PIN
1
2
3
4
5
6
7
8
07267B DCN6485
The electrical connections for the T102 are the same as those described in the Electrical
Connections Section of the T101 Manual - PN 07266 except for the test channel analog
output.
This section supersedes the Analog Output Connections section in the T101 Manual -
PN 07266.
Attach a strip chart recorder and/or data-logger to the appropriate contacts of the analog
output connecter on the rear panel of the analyzer.
A1
+ - +

Figure 3-6. Analog Output Connector

The A1 and A2 channels output a signal that is proportional to the SO
the sample gas.
The output, labeled A3 is special. It can be set by the user (see Test Channel Output
section in the T101 Manual - PN 07266) to output any one of the parameters accessible
through the <TST TST> keys of the units sample display.
Pin-outs for the Analog Output connector at the rear panel of the instrument are:

Table 3-2. Analog output Pin Outs

ANALOG OUTPUT
A1
A2
A3
A4
The default analog output voltage setting of the T102 UV Fluorescence
•
SO Analyzer is 0 – 5 VDC with a range of 0 – 500 ppb.
2
To change these settings, see Analog I/O Configuration and SETUP –
•
RNGE: Analog Output Reporting Range Configuration sections,
respectively, in the T101 Manual - PN 07266.
ANALOG OUT
A2 A3 A4
- + - + -
VOLTAGE OUTPUT
V Out
Ground
V Out
Ground
V Out
Ground
Not Available
Not Available
GETTING STARTED
concentration of
2
CURRENT LOOP OPTION
I Out +
I Out -
I Out +
I Out -
I Out +
I Out -
Not Available
Not Available
23