Mirroring-Group Remote-Probe Vlan - HPE FlexFabric 5930 Series Network Management And Monitoring Command Reference

mirroring-group group-id reflector-port
undo mirroring-group group-id reflector-port
Default
No reflector port is configured for a mirroring group. A port does not act as the reflector port for a
mirroring group.
Views
System view, interface view
Predefined user roles
network-admin
Parameters
group-id: Specifies a mirroring group by its number in the range of 1 to 4. The specified mirroring
group must already exist.
interface-type interface-number: Specifies a port by its type and number.
Usage guidelines
You can configure reflector ports only for remote source groups.
The port to be configured as a reflector port must be a port not in use. Do not connect a network
cable to a reflector port.
When a port is configured as a reflector port, the port restores to the factory default settings. After the
port is configured as a reflector port:
•
You cannot configure other features on the reflector port.
•
You cannot change the duplex mode, and port rate for the reflector port.
Examples
# Create remote source group 1, and configure port FortyGigE 1/0/1 as its reflector port in system
view.
<Sysname> system-view
[Sysname] mirroring-group 1 remote-source
[Sysname] mirroring-group 1 reflector-port fortygige 1/0/1
This operation may delete all settings made on the interface. Continue? [Y/N]: y
# Create remote source group 2, and configure port FortyGigE 1/0/2 as its reflector port in interface
view.
<Sysname> system-view
[Sysname] mirroring-group 2 remote-source
[Sysname] interface fortygige 1/0/2
[Sysname-FortyGigE1/0/2] mirroring-group 2 reflector-port
This operation may delete all settings made on the interface. Continue? [Y/N]: y
Related commands
mirroring-group

mirroring-group remote-probe vlan

Use mirroring-group remote-probe vlan to specify a VLAN as the remote probe VLAN for a
mirroring group.
Use undo mirroring-group remote-probe vlan to remove a remote probe VLAN from a mirroring
group.
253