Mirroring-Group Reflector-Port - HPE FlexFabric 5930 Series Network Management And Monitoring Command Reference

undo mirroring-group group-id monitor-port interface-type interface-number
Default
No monitor port is configured for a mirroring group.
Views
System view
Predefined user roles
network-admin
Parameters
group-id: Specifies a mirroring group by its number in the range of 1 to 4. The specified mirroring
group must already exist.
interface-type interface-number: Specifies a port by its type and number.
Usage guidelines
You can configure monitor ports only for local mirroring groups and remote destination groups.
Do not enable the spanning tree feature on the monitor port of a mirroring group.
For a Layer 2 aggregate interface configured as the monitor port of a local mirroring group, do not
configure its member ports as source ports.
Layer 2 remote port mirroring does not support using Layer 2 aggregate interfaces as source ports or
monitor ports.
Use a monitor port only for port mirroring, so the data monitoring device receives only the mirrored
traffic.
Do not configure a port of an existing mirroring group as a monitor port.
Examples
# Create local mirroring group 1, and configure port FortyGigE 1/0/1 as its monitor port.
<Sysname> system-view
[Sysname] mirroring-group 1 local
[Sysname] mirroring-group 1 monitor-port fortygige 1/0/1
# Create remote destination group 2, and configure port FortyGigE 1/0/2 as its monitor port.
<Sysname> system-view
[Sysname] mirroring-group 2 remote-destination
[Sysname] mirroring-group 2 monitor-port fortygige 1/0/2
Related commands
mirroring-group

mirroring-group reflector-port

Use mirroring-group reflector-port to configure the reflector port for a remote source group.
Use undo mirroring-group reflector-port to remove the reflector port from a remote source group.
Syntax
In system view:
mirroring-group group-id reflector-port interface-type interface-number
undo mirroring-group group-id reflector-port interface-type interface-number
In interface view:
252