Mirroring-Group Monitor-Port (System View) - HPE FlexFabric 5930 Series Network Management And Monitoring Command Reference

Syntax
mirroring-group group-id monitor-port
undo mirroring-group group-id monitor-port
Default
No monitor port is configured for a mirroring group.
Views
Interface view
Predefined user roles
network-admin
Parameters
group-id: Specifies a mirroring group by its number in the range of 1 to 4. The specified mirroring
group must already exist.
Usage guidelines
You can configure monitor ports only for local mirroring groups and remote destination groups.
Do not enable the spanning tree feature on the monitor port of a mirroring group.
For a Layer 2 aggregate interface configured as the monitor port of a local mirroring group, do not
configure its member ports as source ports.
Layer 2 remote port mirroring does not support using Layer 2 aggregate interfaces as source ports or
monitor ports.
Use a monitor port only for port mirroring, so the data monitoring device receives only the mirrored
traffic.
Do not configure a port of an existing mirroring group as a monitor port.
Examples
# Create local mirroring group 1, and configure port FortyGigE 1/0/1 as its monitor port.
<Sysname> system-view
[Sysname] mirroring-group 1 local
[Sysname] interface fortygige 1/0/1
[Sysname-FortyGigE1/0/1] mirroring-group 1 monitor-port
# Create remote destination group 2, and configure port FortyGigE 1/0/2 as its monitor port.
<Sysname> system-view
[Sysname] mirroring-group 2 remote-destination
[Sysname] interface fortygige 1/0/2
[Sysname-FortyGigE1/0/2] mirroring-group 2 monitor-port
Related commands
mirroring-group

mirroring-group monitor-port (system view)

Use mirroring-group monitor-port to configure a port as the monitor port for a mirroring group.
Use undo mirroring-group monitor-port to remove the monitor port from a mirroring group.
Syntax
mirroring-group group-id monitor-port interface-type interface-number
251