In Monitor Link Group View; In Interface View; Configuring The Switchover Delay For The Downlink Interfaces In A Monitor Link Group - HPE FlexFabric 5700 Series Configuration Manual

•
Member ports of Layer 2 aggregation groups
•
S-channel interfaces and S-channel aggregate interfaces
Follow these guidelines when you configure monitor link group member interfaces:
•
To avoid undesired down/up state changes on the downlink interfaces, configure uplink
interfaces before you configure downlink interfaces.
•
To avoid interrupting Monitor Link operation, do not assign the aggregate interface and member
ports of an aggregation group to the same monitor link group.
•
An interface can be assigned to only one monitor link group.

In monitor link group view

To configure member interfaces for a monitor link group in monitor link group view:
Step
1. Enter system view.
2. Enter monitor link group
view.
3. Configure member interfaces
for the monitor link group.

In interface view

To configure member interfaces for a monitor link group in interface view:
Step
1. Enter system view.
2. Enter interface view
3. Configure the current interface
as a member of a monitor link
group.
Configuring the switchover delay for the downlink
interfaces in a monitor link group
Step
1. Enter system view.
2. Enter monitor link group view.
3. Configure the switchover
delay for the downlink
interfaces in the monitor link
group.
Command
system-view
monitor-link group group-id
port interface-type
interface-number { downlink |
uplink }
Command
system-view
interface interface-type
interface-number
port monitor-link group group-id
{ downlink | uplink }
Command
system-view
monitor-link group group-id
downlink up-delay delay
112
Remarks
N/A
N/A
By default, a monitor link group
has no member interfaces.
Remarks
N/A
N/A
By default, the interface is not a
monitor link group member.
Remarks
N/A
N/A
By default, the switchover delay
for the downlink interfaces is 0
seconds. The downlink
interfaces come up as soon as
an uplink interface comes up.