Enabling The Sftp Server; Enabling The Scp Server; Configuring Netconf Over Ssh - HPE FlexNetwork 5510 HI Series Security Configuration Manual

Step
1. Enter system view.
2. Enable the Stelnet server.

Enabling the SFTP server

After you enable the SFTP server on the device, a client can log in to the device through SFTP.
To enable the SFTP server:
Step
1. Enter system view.
2. Enable the SFTP server.

Enabling the SCP server

After you enable the SCP server on the device, a client can log in to the device through SCP.
The device that acts as an SCP server does not support SCP connections initiated by SSH1 clients.
To enable the SCP server:
Step
1. Enter system view.
2. Enable the SCP server.

Configuring NETCONF over SSH

After you enable NETCONF over SSH on the device, a client can perform NETCONF operations on
the device through a NETCONF-over-SSH connection.
When the device acts as a server in the NETCONF-over-SSH connection, connection requests
initiated by SSH1 clients are not supported.
For more information about NETCONF over SSH commands, see Network Management and
Monitoring Command Reference.
To configure NETCONF over SSH:
Step
1. Enter system view.
2. Enable NETCONF over
SSH.
3. Specify a port to listen for
NETCONF-over-SSH
connections.
Command
system-view
ssh server enable
Command
system-view
sftp server enable
Command
system-view
scp server enable
Command
system-view
netconf ssh server enable
netconf ssh server
port-number
333
Remarks
N/A
By default, the Stelnet server is
disabled.
Remarks
N/A
By default, the SFTP server is
disabled.
Remarks
N/A
By default, the SCP server is
disabled.
Remark
N/A
By default, NETCONF over SSH is
disabled.
port
By default, port 830 listens for
NETCONF-over-SSH connections.