Saving Configuration To The Next-Startup Configuration File; Connecting Physical Irf Ports - HPE FlexNetwork HSR6800 Configuration Manual

flow-interval commands on the physical port. For more information about these commands, see
Layer 2—LAN Switching Command Reference.
To bind physical ports to IRF ports:
Step
1. Enter system view.
2. Create an IRF port and
enter IRF port view.
3. Bind a physical IRF port to
the IRF port.
Saving configuration to the next-startup
configuration file
Save the running configuration before converting to the IRF mode. The mode change requires a
reboot, which can cause all unsaved settings to be lost.
Perform the following task in any view:
Task
Save the running configuration to
the startup configuration file.

Connecting physical IRF ports

When you connect two neighboring IRF members, connect the physical ports of IRF-port 1 on one
member to the physical ports of IRF-port 2 on the other, as shown in
Follow these guidelines when selecting transceiver modules and cables:
•
Use SFP+ transceiver modules and fibers for long-distance connection.
•
When you connect SFP+ ports, connect the transmit port of an SFP+ transceiver module at one
end to the receive port of an SFP+ transceiver module at the other end.
•
The transceiver modules at the two ends of an IRF link must be the same type.
For more information about transceiver modules, see the device installation guide.
IMPORTANT:
No intermediate devices are allowed between neighboring members.
Command
system-view
irf-port port-number
port group interface interface-type
interface-number [ mode { enhanced
| normal } ]
Command
save [ safely ] [ backup | main ] [ force ]
14
Remarks
N/A
By default, no IRF port is
created.
By default, no physical ports are
bound to any IRF port.
Repeat this step to assign more
physical ports to the IRF port.
Every IRF port can have up to
four physical ports.
Figure 9.