Configuring An Interface To Send Calling Number During An Outgoing Call; Setting The Local Management Isdn B Channel - HPE FlexNetwork MSR Series Comware 5 Layer 2 - Wan Access Configuration Manual

Step
Enter interface view.
2.
Set the called number or
3.
subaddress to be checked
during a digital incoming call.
Configuring an interface to send calling number
during an outgoing call
Set this command to reduce cost in networks that charge the calling side by providing advantageous
accounting numbers for users.
To configure an interface to send the calling number during an outgoing call:
Step
Enter system view.
1.
Enter interface view.
2.
Configure the interface to
3.
send the calling number
during an outgoing call.

Setting the local management ISDN B channel

Configured with the isdn bch-local-manage command, the router operates in local B-channel
management mode to select available B channels for calls. Despite this, the connected exchange
has higher priority in B channel selection. If the B channel the router selected for a call is different
from the one indicated by the exchange, the one indicated by the exchange is used for
communication.
Configured with the isdn bch-local-manage exclusive command, the router operates in exclusive
local B-channel management mode. In this mode, the B channel selected by the router must be
adopted for communication. In the Channel ID information element of the call Setup message sent
for a call, the router indicates that the B channel is mandatory and unchangeable. If the connected
exchange indicates a B channel different from the one selected by the router, call failure occurs.
To set the local management ISDN B channel:
Step
Enter system view.
1.
Enter interface view.
2.
Command
interface interface-type
interface-number
isdn check-called-number
check-index called-party-number
[ : subaddress ]
Command
system-view
interface interface-type
interface-number
isdn calling calling-number
Command
system-view
interface interface-type
interface-number
68
Remarks
N/A
Optional.
No called number or subaddress
is configured by default. When
you configure this command, the
called number and subaddress
are separated with string "space:
space."
Remarks
N/A
N/A
Optional.
Calling number is not sent by
default.
Remarks
N/A
N/A