Juniper ACX1000 Configuration Manual page 477

Related
Documentation
Copyright © 2017, Juniper Networks, Inc.
Configure the interfaces that participate in the VSTP instance.
8.
Enable configuration of the interface:
a.
[edit ... protocols vstp vlan vlan-id]
user@host# edit interface interface-name
Configure the interface priority:
b.
[edit ... protocols vstp vlan vlan-id interface interface-name]
user@host# set priority interface-priority
(Optional) Configure the interface as an edge port:
c.
[edit ... protocols vstp vlan vlan-id interface interface-name]
user@host# set edge
Verify the VSTP configuration:
9.
[edit]
protocols {
vstp {
force-version stp; # Optional.
interface interface-name {
priority interface-priority;
cost interface-link-cost; # Optional.
mode (p2p | shared);
edge; # Optional.
}
vlan vlan-id {
bridge-priority bridge-priority;
max-age seconds;
hello-time seconds;
forward-delay seconds; # Optional.
interface interface-name {
priority interface-priority;
cost interface-link-cost; # Optional.
mode (p2p | shared);
edge; # Optional.
}
}
}
}
}
Layer 2 Control Protocol on ACX Series Routers on page 404
Configuring Multiple Spanning-Tree Protocol on page 413
Configuring Rapid Spanning-Tree Protocol on page 411
Tracing Spanning-Tree Operations on page 421
Configuring MST Instances on a Physical Interface on page 415
Disabling MSTP on page 417
Chapter 12: Configuring Layer 2 Control Protocol
419