Juniper ACX1000 Configuration Manual page 568

ACX Series Universal Access Router Configuration Guide
510
fragment-threshold bytes;
minimum-links number;
mrru bytes;
short-sequence;
family inet {
address address;
}
You can configure the address family as MPLS for the LSQ interfaces in an MLPPP
bundle.
PPP control protocol support depends on the processing of the PPP application for
MLPPP bundle interfaces IPv4, Internet Protocol Control Protocol (IPCP), PPP Challenge
Handshake Authentication Protocol (CHAP), and Password Authentication Protocol
(PAP) applications are supported for PPP.
Drop timeout configuration is not applicable to ACX routers
The member links across MICs cannot be bundled. Only physical interfaces on the
same MIC can be bundled.
Fractional T1 and E1 interfaces are not supported. CoS is supported only for full T1 and
E1 interfaces. Selective time slots of T1/E1 cannot be used and full T1/E1 interfaces
must be used.
Detailed statistics displayed depend on the parameters supported by the hardware.
The counters that are supported by the hardware are displayed with appropriate values
in the output of the
show interfaces lsq-fpc/pic/port detail
sample output, the fields that are displayed with a value of 0 denote the fields that
are not supported for computation by ACX routers. In the lsq- interface statistics, non-
fragment statistics of the bundle are not accounted. Non-fragments are typically
treated as single-fragment frames and counted in the fragment statistics.
user@host# show interfaces lsq-1/1/0 detail
Physical interface: lsq-1/1/0, Enabled, Physical link is Up
Interface index: 162, SNMP ifIndex: 550, Generation: 165
Description: LSQ-interface
Link-level type: LinkService, MTU: 1504
Device flags : Present Running
Interface flags: Point-To-Point SNMP-Traps Internal: 0x0
Last flapped : 2015-06-22 19:01:47 PDT (2d 04:56 ago)
Statistics last cleared: 2015-06-23 05:01:49 PDT (1d 18:56 ago)
Traffic statistics:
Input bytes :
Output bytes :
Input packets:
Output packets:
IPv6 transit statistics:
Input bytes :
Output bytes :
Input packets:
Output packets:
Frame exceptions:
Oversized frames
Errored input frames
Input on disabled link/bundle
Output for disabled link/bundle
Queuing drops
command. In the following
108824 208896 bps
90185 174080 bps
1075
1061
0
0
0
0
0
0
0
0
0
Copyright © 2017, Juniper Networks, Inc.
256 pps
256 pps