Configuring Interface Encapsulation On Physical Interfaces In Acx Series - Juniper ACX1000 Configuration Manual

Related
Documentation

Configuring Interface Encapsulation on Physical Interfaces in ACX Series

Copyright © 2017, Juniper Networks, Inc.
encapsulation, you can configure interfaces to support the PPP Challenge Handshake
Authentication Protocol (CHAP) and Password Authentication Protocol (PAP).
For full T1/E1 interfaces on which PPP encapsulation needs to be enabled, create the
T1/E1 interfaces out of channelized T1/E1 interfaces (CT1/CE1) by including the
statement at the [edit chassis fpc fpc-slot pic pic-slot]
[edit chassis fpc fpc-slot pic pic-slot]
user@host# set framing (t1 | e1);
Configure a CT1 port down to a T1 channel. On the CT1 interface, set the
option and then set the interface type as T1.
[edit interfaces ct1-mpc-slot/mic-slot/port-number]
user@host# set no-partition interface-type t1
Configure a CE1 port down to an E1 channel. On the CE1 interface, set the
option and then set the interface type as E1.
[edit interfaces ce1-mpc-slot/mic-slot/port-number]
user@host# set no-partition interface-type t1
For NxDS0 interfaces on which PPP encapsulation needs to be enabled, partition the
CE1 and CT1 interfaces by including the
timeslots interface-type ds
statements at the [
interface-type ds
The following operational mode commands can be used to view PPP configuration
settings and statistical details:
The
show ppp address-pool
The command is used to display PPP session information for an
show ppp interface
interface.
The
show ppp statistics
The
show ppp summary
PPP-configured interfaces.
The
show interfaces e1-fpc/pic/port
commands are used to display the PPP settings of a specific E1, T1, and
ds-fpc/pic/port
DS interface, respectively.
Configuring Interface Encapsulation on Physical Interfaces in ACX Series on page 501
encapsulation on page 1511
ppp-options on page 1672
Point-to-Point Protocol (PPP) encapsulation is the default encapsulation type for physical
interfaces. You need not configure encapsulation for any physical interfaces that support
Chapter 16: Configuring Point-to-Point Protocol (PPP)
ce1-x/y/z partition partition-number timeslots
and ct1-x/y/z partition partition-number timeslots timeslots
edit interfaces interface-name
command is used to display PPP address pool information.
command is used to display PPP session statistics.
command is used to display summary information about
,
show interfaces t1-fpc/pic/port
framing
hierarchy level:
no-partition
no-partition
] hierarchy level.
, and
show interfaces
501