Trap Receiver V3 > Add - Advantech EKI-9516P-HV User Manual

Item
UDP Port
Refresh
Add
Remove
To add a new SNMP trap receiver:
Click System > Advanced Configuration > SNMP > Trap Receiver v3 > Add.
Figure 4.54 System > Advanced Configuration > SNMP > Trap Receiver v3 >
The following table describes the items in the previous figure.
Item
Host IP Address
User Name
Notify Type
Security Level
Retries
EKI-9500 Series User Manual
Description
The UDP port on the SNMP management host that will receive the
SNMP notifications. If no value is specified when configuring a
receiver, the default UDP port value is used.
Click Refresh to update the screen.
Click Add to add a new SNMP trap receiver.
Click Remove to remove the selected entries.
Add
Description
The IP address of the SNMP management host that will receive traps
generated by the device.
The name of the SNMP user that is authorized to receive the SNMP
notification.
The type of SNMP notification to send the SNMP management host:

Inform: An SNMP message that notifies the host when a certain
event has occurred on the device. The message is acknowl-
edged by the SNMP management host.

Trap: An SNMP message that notifies the host when a certain
event has occurred on the device. The message is not acknowl-
edged by the SNMP management host.
The security level associated with the SNMP user, which is one of the
following:

No Auth No Priv: No authentication and no data encryption (no
security).

Auth No Priv: Authentication, but no data encryption. With this
security level, users send SNMP messages that use an MD5
key/password for authentication, but not a DES key/password
for encryption.

Auth Priv: Authentication and data encryption. With this security
level, users send an MD5 key/password for authentication and a
DES key/password for encryption.
The number of times to resend an inform message that is not
acknowledged by the SNMP receiver.
64