Table of Contents
Advertisement
To access this page, click Routing > IP > Interface Summary.
The following table describes the items in the previous figure.
Item
Interface
Status
IP Address
Subnet Mask
Admin Mode
State
MAC Address
IP MTU
Refresh
Edit
Details
4.5.2.3
Interface Configuration
Use the Routing IP Interface Configuration page to configure the IP routing settings
for each non-loopback interface.
EKI-9500 Series User Manual
Figure 4.279 Routing > IP > Interface Summary
Description
The interface associated with the rest of the data in the row. When
viewing details about the routing settings for an interface, this field
identifies the interface being viewed.
Indicates whether the interface is capable of routing IP packets (Up) or
cannot route packets (Down). For the status to be Up, the routing
mode and administrative mode for the interface must be enabled.
Additionally, the interface must have an IP address and be physically
up (active link).
The IP address of the interface.
The IP subnet mask for the interface (also known as the network mask
or netmask). It defines the portion of the interface's IP address that is
used to identify the attached network.
The administrative mode of the interface, which is either Enabled or
Disabled.
The state of the interface, which is either Active or Inactive. An inter-
face is considered active if the link is up, and the interface is in a for-
warding state.
The burned-in physical address of the interface. The format is six two-
digit hexadecimal numbers separated by colons, for example
00:06:29:32:81:40.
The largest IP packet size the interface can transmit, in bytes. The IP
Maximum Transmission Unit (MTU) is the maximum frame size minus
the length of the Layer 2 header.
Click Refresh to update the screen.
Click Edit to edit the selected entries.
Click Details to open a window and display additional information.
250
Advertisement
Table of Contents
