Figure 4.90 System > Connectivity > Ipv6 Neighbors > Add - Advantech EKI-9516P-HV User Manual

Item
Add
Remove
To add a new network port IPv6 neighbor:
Click System > Connectivity > IPv6 Neighbors > Add.
Figure 4.90 System > Connectivity > IPv6 Neighbors > Add
The following table describes the items in the previous figure.
Item
IPv6 Address
MAC Address
Submit
Cancel
4.3.5.4 Service Port IPv4
Use the Service Port IPv4 Configuration page to configure network information on the
service port. The service port is a dedicated Ethernet port for out-of-band manage-
ment of the device. Traffic on this port is segregated from operational network traffic
on the switch ports and cannot be switched or routed to the operational network.
To access this page, click System > Connectivity > Service Port IPv4.
Figure 4.91 System > Connectivity > Service Port IPv4
The following table describes the items in the previous figure.
Item
Service Port Configu-
ration Protocol
EKI-9500 Series User Manual
Description
Click Add to add a new network port IPv6 neighbor.
Click Remove to remove the selected entries.
Description
The IPv6 address of a neighbor device that has been reachable on
the local link through the network interface.
The MAC address of the neighboring device.
Click Submit to save the values.
Click Cancel to close the window.
Description
Specify how the device acquires network information on the service
port:

BOOTP: During the next boot cycle, the BOOTP client on the
device broadcasts a BOOTP request in an attempt to acquire
information from a BootP server on the network.

DHCP: During the next boot cycle, the DHCP client on the
device broadcasts a DHCP request in an attempt to acquire
information from a DHCP server on the network.

None: The device does not attempt to acquire network informa-
tion dynamically.
94