Power Over Ethernet; Figure 4.185 Management > Snmp > Snmp Trap - Advantech EKI-7712 Series User Manual

To access this page, click Management > SNMP > SNMP Trap.
The following table describes the items in the previous figure.
Item
IP Address
Community Name/
User Name
Version
Add
The ensuing table for Trap Host Status settings are informational only: No., IP
Address, Community Name, Version and Delete (click to delete the desired IP
address).
4.9.3

Power Over Ethernet

Power Over Ethernet is the function supplying power to Powered Devices (PD)
through the switch in the event that AC power is not readily available.
Power over Ethernet can be used for the following areas:
Surveillance devices

I/O sensors for security requirements

Wireless access points

Series
EKI
4.9.3.1 PoE System Settings
The PoE System Settings page allows you to configure the overload disconnect and
the maximum available wattage.
Figure 4.185 Management > SNMP > SNMP Trap
Description
Enter the IP address to designate the SNMP trap host.
Click the drop-down menu to select a defined community name.
Click the drop-down menu to designate the SNMP version credentials
(v1, v2c - trap, v2c - inform, v2c - trap or v2c - inform).
Click Add to save the values and update the screen.
Supported Models
EKI-7708E/G-4FP, EKI-7710E/G-2CP, EKI-7712E/G-4FP, EKI-7720G-
4FP, EKI-7428G-4CP
122 EKI-7720 Series User Manual