Power Over Ethernet; Figure 4.107 Management > Snmp > Snmp Trap; Figure 4.108 Management > Power Over Ethernet > Poe System Settings - Advantech EKI-7428 Series User Manual

4.9.2.4 SNMP Trap
The SNMP Trap page allows you to set the IP address of the node and the SNMP
credentials corresponding to the version that is included in the trap message.
To access this page, click Management > SNMP > SNMP Trap.
The following table describes the items in the previous figure.
Item
IP Address
Community Name
Version
Add
The ensuing table for Trap Host Status settings are informational only: No., IP
Address, Community Name, Version and Delete (click to delete the desired IP
address).
4.9.3

Power Over Ethernet

Power Over Ethernet is the function supplying power to Powered Devices (PD)
through the switch in the event that AC power is not readily available.
Power over Ethernet can be used for the following areas:

Surveillance devices

I/O sensors for security requirements

Wireless access points
4.9.3.1 PoE System Settings
The PoE System Settings page allows you to configure the overload disconnect and
the maximum available wattage.
To access this page, click Management > Power Over Ethernet > PoE System
Settings.
Figure 4.108 Management > Power Over Ethernet > PoE System Settings
Figure 4.107 Management > SNMP > SNMP Trap
Description
Enter the IP address to designate the SNMP trap host.
Click the drop-down menu to select a defined community name.
Click the drop-down menu to designate the SNMP version credentials
(v1 or v2c).
Click Add to save the values and update the screen.
101 EKI-7428 Series User Manual