Connectivity; Figure 4.86 System > Configuration Storage > Copy - Advantech EKI-9516P-HV User Manual

To access this page, click System > Configuration Storage > Copy.
The following table describes the items in the previous figure.
Item
Source File
Destination File
Submit
4.3.5

Connectivity

4.3.5.1 IPv4
Use the IPv4 Network Connectivity page to configure and view the IPv4 network con-
nectivity information on the network interface. The network interface is the logical
interface that allows remote management of the device via any of the front-panel
switch ports. To enable management of the device over an IPv4 network by using a
Web browser, SNMP, Telnet, or SSH, you must first configure it with an IP address,
subnet mask, and default gateway. The configuration parameters associated with the
network interface do not affect the configuration of the front-panel ports through
which traffic is switched or routed.
To access this page, click System > Connectivity > IPv4.
EKI-9500 Series User Manual
Figure 4.86 System > Configuration Storage > Copy
Description
Select the configuration file that will overwrite the contents in the
selected destination file. The source file options are as follows:

Running Config: The file that contains the configuration that is
currently active on the system. Copying the Running Config file
to the Startup Config file is effectively the same as performing a
Save.

Startup Config: The file that contains the configuration that loads
when the system boots.

Backup Config: The file that is used to store a copy of the run-
ning or startup configuration.
Select file to be overwritten by the contents in the selected source file.
The destination file options are as follows:

Startup Config: The file that contains the configuration that loads
when the system boots.

Backup Config: The file that is used to store a copy of the run-
ning or startup configuration.
Click Submit to save the values and update the screen.
Figure 4.87 System > Connectivity > IPv4
90