Table of Contents
Advertisement
Item
Description
Receiver Index
The sFlowReceiver for this sFlow counter poller. The specified
Receiver Index must be associated with an active sFlow receiver. If a
receiver expires, all pollers associated with the receiver will also
expire.
Poller Interval
The maximum number of seconds between successive samples of
the counters associated with this data source. A sampling interval of 0
disables counter sampling.
Refresh
Click Refresh to update the screen.
Add
Click Add to add a new poller data.
Edit
Click Edit to edit the selected entries.
Remove
Click Remove to remove the selected entries.
To add a new poller data:
Click System > Advanced Configuration > sFlow > Poller > Add.
Figure 4.44 System > Advanced Configuration > sFlow > Poller > Add
The following table describes the items in the previous figure.
Item
Description
Poller Data Source
The sFlowDataSource for this sFlow poller. The sFlow agent supports
physical ports as sFlow data sources.
Receiver Index
The sFlowReceiver for this sFlow counter poller. The specified
Receiver Index must be associated with an active sFlow receiver. If a
receiver expires, all pollers associated with the receiver will also
expire.
Poller Interval (Sec-
The maximum number of seconds between successive samples of
onds)
the counters associated with this data source. A sampling interval of 0
disables counter sampling.
Submit
Click Submit to save the values.
Cancel
Click Cancel to close the window.
Sampler
Use the sFlow Sampler Configuration page to add, remove, or edit an sFlow sampler
instance on a port (data source). Configuring a sampler instance allows the sFlow
agent to perform statistical packet-based sampling of switched or routed packet
flows. Packet flow sampling creates a steady, but random, stream of sFlow data-
grams that are sent to the sFlow receiver.
57
EKI-9500 Series User Manual
Advertisement
Table of Contents
