Figure 4.307Security > Tacacs+ > Source Interface Configuration - Advantech EKI-9516P-HV User Manual

Item
Refresh
Cancel
4.6.3.4 Source Interface Configuration
Use the TACACS+ Source Interface Configuration page to specify the physical or
logical interface to use as the TACACS+ client source interface. When an IP address
is configured on the source interface, this address is used for all TACACS+ communi-
cations between the local TACACS+ client and the remote TACACS+ server. The IP
address of the designated source interface is used in the IP header of TACACS+
management protocol packets. This allows security devices, such as firewalls, to
identify all source packets coming from a specific device.
To access this page, click Security > TACACS+ > Source Interface Configuration.
Figure 4.307 Security > TACACS+ > Source Interface Configuration
The following table describes the items in the previous figure.
Item
Type
Interface
VLAN ID
Submit
Refresh
Cancel
4.7 QoS
4.7.1 Access Control Lists
4.7.1.1 Summary
Use the Access Control List Summary page to add and remove Access Control Lists
(ACLs). ACLs are used to provide traffic flow control, restrict contents of routing
updates, decide which types of traffic are forwarded or blocked, and above all pro-
vide security for the network. There are three main steps to configuring an ACL:
1. Create an ACL. (Use the current page.)
2. Add rules to the ACL and configure the rule criteria. (Use the Access Control
List Configuration page.)
3. Apply the ACL to one or more interfaces. (Use the Access Control List Interface
Summary page.)
Description
Click Refresh to update the screen.
Click Cancel to restore default value.
Description
The type of interface to use as the source interface:

None: The primary IP address of the originating (outbound) inter-
face is used as the source address.

Interface: The primary IP address of a physical port is used as
the source address.

VLAN: The primary IP address of a VLAN routing interface is
used as the source address.
When the selected Type is Interface, select the physical port to use as
the source interface.
When the selected Type is VLAN, select the VLAN to use as the
source interface. The menu contains only the VLAN IDs for VLAN rout-
ing interfaces.
Click Submit to save the values and update the screen.
Click Refresh to update the screen.
Click Cancel to restore default value.
277 EKI-9500 Series User Manual