Tcp Modbus Settings; Figure 4.111 Management > Snmp > Snmp Trap; Figure 4.112 Management > Tcp Modbus > Tcp Modbus Settings - Advantech EKI-7706 Series User Manual

4.9.2.4 SNMP Trap
The SNMP Trap page allows you to set the IP address of the node and the SNMP
credentials corresponding to the version that is included in the trap message.
To access this page, click Management > SNMP > SNMP Trap.
The following table describes the items in the previous figure.
Item
IP Address
Community Name
Version
Add
The ensuing table for Trap Host Status lists the following settings (informational
only):
No., IP Address, Community Name, Version and Delete
4.9.3

TCP Modbus Settings

The TCP Modbus function allows for client-server communication between a switch
module (server) and a device in the networking running MODBUS client software
(client).
4.9.3.1 TCP Modbus Settings
The TCP Modbus Settings page allows you to configure the modbus function.
To access this page, click Management > TCP Modbus > TCP Modbus Settings.
Figure 4.112 Management > TCP Modbus > TCP Modbus Settings
The following table describes the items in the previous figure.
Item
State
EKI-7706 Series User Manual
Figure 4.111 Management > SNMP > SNMP Trap
Description
Enter the IP address to designate the SNMP trap host.
Click the drop-down menu to select a defined community name.
Click the drop-down menu to designate the SNMP version credentials
(v1 or v2c).
Click Add to save the values and update the screen.
Description
Click Disabled or Enabled to set the TCP Modbus state.
109