Figure 4.152System > Utilities > Ip Address Conflict - Advantech EKI-9516P-HV User Manual

Item
Results
Submit
4.3.16.6 IP Address Conflict
Use the IP Address Conflict Detection page to determine whether the IP address
configured on the device is the same as the IP address of another device on the
same LAN (or on the Internet, for a routable IP address) and to help you resolve any
existing conflicts. An IP address conflict can make both this system and the system
with the same IP address unusable for network operation.
To access this page, click System > Utilities > IP Address Conflict.
Figure 4.152 System > Utilities > IP Address Conflict
Description
The results of the TraceRoute, which are displayed in the following
format:
1 3001::1 708 ms 41 ms 11 ms
2 4001::2 250 ms 200 ms 193 ms
3 5001::3 289 ms 313 ms 278 ms
4 6001::4 651 ms 41 ms 270 ms
5 :: * N * N * N
Hop Count = 4 Last TTL = 5 Test attempt = 1 Test Success = 0
For each TTL value probed, the results show the IP address of the
router that responded to the probes and the response time for each
probe. If no response is received for probes with a particular TTL, the
IP address is reported as 0.0.0.0.
An error code may be printed with the response time for each probe.
The error codes signify that either no response was received or an
ICMP Destination Unreachable message was received with error
codes as follows:

* no response was received to the probe

P: Protocol unreachable (RFC 792)

N: Network unreachable (RFC 792)

H: Host unreachable (RFC 792)

F: Fragmentation needed and DF set (RFC 792)

S: Source route failed (RFC 792)

A: Communication with Destination Network is Administratively
Prohibited (RFC 1122)

C: Communication with Destination Host is Administratively Pro-
hibited (RFC 1122)
The Hop Count is the number of sets of probes sent, each set of
probes having a particular TTL. The Last TTL is the TTL sent in the
final set of probes. The Test Attempt value shows the number of
probes sent. The Test Success value shows the number of probes
that received a response.
Click Submit to initiates the TraceRoute.
147 EKI-9500 Series User Manual