Table of Contents
Advertisement
The following table describes the items in the previous figure.
Item
Reset
4.3.16.2
Ping
Use the Ping page to tell the switch to send a Ping request to a specified IP address.
You can use this feature to check whether the switch can communicate with a partic-
ular network host.
To access this page, click System > Utilities > Ping.
The following table describes the items in the previous figure.
Item
Host Name or IP
Address
Count
Interval (Seconds)
Size (Bytes)
Source
IP Address
Interface
Status
Results
EKI-9500 Series User Manual
Description
Click Reset to initiates the system reset action after displaying a con-
firmation message.
Figure 4.148 System > Utilities > Ping
Description
The DNS-resolvable hostname or IP address of the system to ping.
Enter the number of ICMP echo request packets to send to the host.
Enter the number of seconds to wait between sending ping packets.
The size of the ping packet, in bytes. Changing the size allows you to
troubleshoot connectivity issues with a variety of packet sizes, such
as large or very large packets.
The source IP address or interface to use when sending the echo
request packets. If source is not required, select None as source
option.
The source IP address to use when sending the Echo requests pack-
ets. This field is enabled when IP Address is selected as source
option.
The interface to use when sending the Echo requests packets. This
field is enabled when Interface is selected as source option.
The current status of the ping test, which can be:
Not Started: The ping test has not been initiated since viewing
the page.
In Progress: The ping test has been initiated and is running.
Stopped: The ping test was interrupted by clicking the
ton.
Done: The test has completed, and information about the test is
displayed in the Results area.
The results of the ping test, which includes information about the reply
(if any) received from the host.
142
Stop
but-
Advertisement
Table of Contents
