Advantech EKI-9516P-HV User Manual page 164

Item
Status
Results
Start
Stop
4.3.16.5 TraceRoute IPv6
Use the TraceRoute IPv6 page to determine the layer 3 path a packet takes from the
device to a specific IP address or hostname. When you initiate the IPv6 TraceRoute
command by clicking the Submit button, the device sends a series of IPv6 TraceR-
oute probes toward the destination. The results list the IP address of each layer 3
device a probe passes through until it reaches its destination - or fails to reach its
destination and is discarded. The information you enter on this page is not saved as
part of the device configuration.
Description
The current status of the TraceRoute, which can be:

Not Started: The TraceRoute has not been initiated since view-
ing the page.

In Progress: The TraceRoute has been initiated and is running.

Stopped: The TraceRoute was interrupted by clicking the Stop
button.

Done: The TraceRoute has completed, and information about
the TraceRoute is displayed in the Results area.
The results of the TraceRoute, which are displayed in the following
format:
1 10.20.24.1 0 ms 0 ms 0 ms
2 66.20.17.9 10 ms 0 ms 10 ms
3 66.20.246.82 10 ms 20 ms 10 ms
4 129.20.4.4 20 ms 10 ms 40 ms
5 129.20.3.55 80 ms 80 ms 90 ms
6 129.20.5.246 80 ms 80 ms 80 ms
7 198.20.90.26 70 ms 70 ms 70 ms
8 216.20.255.105 90 ms 70 ms 80 ms
9 63.20.216.155 80 ms 80 ms 90 ms
Hop Count = 9 Last TTL = 9 Test attempt = 27 Test Success = 27
For each TTL value probed, the results show the IP address of the
router that responded to the probes and the response time for each
probe. If no response is received for probes with a particular TTL, the
IP address is reported as 0.0.0.0.
An error code may be printed with the response time for each probe.
The error codes signify that either no response was received or an
ICMP Destination Unreachable message was received with error
codes as follows:

* no response was received to the probe

P: Protocol unreachable (RFC 792)

N: Network unreachable (RFC 792)

H: Host unreachable (RFC 792)

F: Fragmentation needed and DF set (RFC 792)

S: Source route failed (RFC 792)

A: Communication with Destination Network is Administratively
Prohibited (RFC 1122)

C: Communication with Destination Host is Administratively Pro-
hibited (RFC 1122)
The Hop Count is the number of sets of probes sent, each set of
probes having a particular TTL. The Last TTL is the TTL sent in the
final set of probes. The Test Attempt value shows the number of
probes sent. The Test Success value shows the number of probes
that received a response.
Click Start to initiates the TraceRoute.
Click Stop to interrupts the running TraceRoute.
145 EKI-9500 Series User Manual