Figure 4.101System > Logs > Hosts - Advantech EKI-9516P-HV User Manual

Item
Severity
Component
Description
Refresh
4.3.7.4 Hosts
Use the Logging Hosts page to configure remote logging hosts where the switch can
send logs.
To access this page, click System > Logs > Hosts.
The following table describes the items in the previous figure.
Item
Host
Status
Port
Severity Filter
Refresh
Add
Edit
Remove
To add a new host:
EKI-9500 Series User Manual
Description
The severity level associated with the log entry. The severity can be
one of the following:

Emergency (0): The device is unusable.

Alert (1): Action must be taken immediately.

Critical (2): The device is experiencing primary system failures.

Error (3): The device is experiencing non-urgent failures.

Warning (4): The device is experiencing conditions that could
lead to system errors if no action is taken.

Notice (5): The device is experiencing normal but significant
conditions.

Info (6): The device is providing non-critical information.

Debug (7): The device is providing debug-level information.
The component that has issued the log entry.
The text description for the log entry.
Click Refresh to update the screen.
Figure 4.101 System > Logs > Hosts
Description
The IP address or DNS-resolvable host name of the remote host to
receive log messages.
Indicates whether the host has been configured to be actively logging
or not.
The UDP port on the logging host to which syslog messages are sent.
Severity level threshold for log messages. All log messages with a
severity level at and above the configured level are forwarded to the
logging host.
Click Refresh to update the screen.
Click Add to add a new host.
Click Edit to edit the selected entries.
Click Remove to remove the selected entries.
102