Security and authentication
11.6 Management Access Control List
11.6
Management Access Control List
This section describes the commands relevant for working with the management access
control list.
11.6.1
show authorized-managers
Description
This command shows the information about the configuration of the authorized managers.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show authorized-managers[ip-source<ip-address>]
The parameters have the following meaning:
Parameters
ip-source
ip-address
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 30)".
Result
The information about the configuration of the authorized managers is displayed.
520
or
cli#
Description
Keyword for the network or host address
Value for an IP address
Range of values
-
Enter a valid IP address
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07