Siemens SCALANCE XM-400 Configuration Manual page 397

Translation
{enabled | disabled}]
The parameters have the following meaning:
Parameter
Network
Mask
AreaId
allowAll
denyAll
advertise
not-advertise
Translation
enabled
disabled
Result
The address range is created.
Further notes
You delete the address range with the
You can display the status of this function and other information with the
area-range / summary-address
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
Description
IP address of the address range
Subnet mask of the address range
Area ID
The backbone area generates an LSA
message of Type 5 for the address range.
LSA messages of Type 7 also generated
for this address range in the connected
NSSAs.
No LSA is of Type 5 or Type 7 is
generated for the address range.
The address range is advertised outside
the areas.
In the backbone area, the router
generates an LSA message of Type 5.
If the Area ID is not 0.0.0.0, the router
generates an LSA message of Type 7 in
an NSSA
No LSA messages of Type 5 are
generated in the backbone area. The
NSSAs connected to the backbone area
generate LSA messages of Type 7. The
other areas do not generate any LSA
Keyword for the P bit. The P bit indicates
to the NSSA-ABR whether the LSA
message of Type 7 is translated to Type 5.
P bit = 1.
LSA message is translated
P bit = 0.
LSA message is not translated
no summary-address
command
Layer 3 functions
9.3 OSPFv2
Range of values / note
specify the IP address
specify the subnet mask.
specify a valid ID.
x.x.x.x
x = 255
0.0.0.0 = backbone area
-
-
-
-
-
-
-
command.
show ip ospf -
397