Commands In The Router Configuration Mode; Asbr Router - Siemens SCALANCE XM-400 Configuration Manual

9.3.13

Commands in the Router Configuration mode

This section describes commands that you can call up in the Router Configuration mode.
In the Global Configuration mode, enter the
Commands relating to other topics that can be called in the Global Configuration mode can
be found in the relevant sections.
● If you exit the Router Configuration mode with the
● If you exit the Router Configuration mode with the
Requirement
The commands are available if the following requirements are met:
● The device supports the routing function.
● The routing function is enabled
● The interface is a router port
9.3.13.1

ASBR Router

Description
With his command, you specify that the router is an Autonomous System Boundary Router
(ASBR).
Note
This command is available only with layer 3.
Requirement
You are in the OSPF Router configuration mode.
The command prompt is as follows:
cli(config-ospf)#
Syntax
Call the command without parameters:
ASBR Router
Result
The autonomous system boundary router is enabled.
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
Global Configuration mode.
Privileged EXEC mode.
command to change to this mode.
router ospf
command, you return to the
exit
command, you return to the
end
Layer 3 functions
9.3 OSPFv2
371