No Ip Domain Lookup; Ip Name-Server - Siemens SCALANCE XM-400 Configuration Manual

Result
The DNS client of the device is enabled and when necessary sends queries to the DNS
server.
7.1.11.12

no ip domain lookup

Description
This command disables the DNS client of the device.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no ip domain lookup
Result
The DNS client of the device is disabled.
7.1.11.13

ip name-server

Description
This command specifies an IP address of a DNS server. If there is more than one server,
you can specify the order in which the servers are queried. To allow this, the optional
parameter
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
ip name-server ipv4 <ip-address> [index <id1-3>]
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
is available. The server with the lowest index is queried first.
index
Network protocols
7.1 IPv4 protocol
247